CAN-bus to POF or HCS fiber optic converter, DL-CAN
The DL-CAN modules connect CAN field bus networks (e.g. CAN, CANopen, DeviceNet) via POF (Plastic Optical Fiber) or HCS (Hard Clad Silica) fiber optics. With the help of this innovative system, an optical point-to-point structure is possible. These modules are equiped with FiberView. The "traffic light" LEDs gives you an indication of the quality of the fiber optic link.
Product variants
| Article Number | Product Name | |
|---|---|---|
| 010007401 + | DL-CAN/1x13-POF-ST CAN/POF/PzP | + Request quote |
| CAN-bus to POF fiber optic converter for a poin-to-point conection, ST adapter. | ||
| 010007411 + | DL-CAN/1x13-HCS-ST CAN/HCS/PzP | + Request quote |
| CAN-bus to HCS fiber optic converter for a poin-to-point conection, ST adapter. | ||
Description
The DL CAN systems connect CAN field bus networks (e.g. CAN, CANopen, DeviceNet) via fiber optics. With the help of this innovative system, optical bus, star, tree and mixed structures are possible.
LEDs and potential-free contacts of a fault detector relay are able to signal defective states.
FiberView works similarly to a traffic light. If the “traffic light” is green, everything is fine. If the yellow LED lights, the budget is still tolerable, but already below a certain system reserve. Additionally to the LED, this pre-warning level is also signaled by a potential-free contact. If the “traffic light” turns red there is a serious error.
Specifications
- FO-connector:
- ST
- Fiber type:
- POF 980/1000µm/HCS200/230µm
- Optical budget:
- 12 dB
- FO range:
- POF 50m (180 dB/km) / HCS 200m (180 dB/km)
- Wavelength:
- POF 650nm / HCS 850nm
- Data rate:
- 10, 20, 22,2, 50, 100, 125, 250, 500, 800, 1000 KBaud Switchable: none or wave impedance (Rw + Rpd + Rpu)
- Transmission type:
- Half duplex
- Indentifier:
- 11 Bit, 29 Bit or both
- Terminating resistor:
- Switchable: none or wave impedance (Rw + Rpd + Rpu)
- CAN cable length:
- Acc. to CAN Specification
- CAN connector:
- 9-pole Sub-D female and 6-pole terminal
- Status LEDs:
- Power supply (green) / Failure (red) / Data receive (green) / Status (red) / FiberView (red, yellow, green)
- Power supply:
- 12 to 30 VDC, other voltages on request
- Power consumption:
- 5 Watts, 200 mA (24 V)
- Galvanic isolation:
- 500 VDC (24 VDC <> CAN)
- Operating temperature:
- -40°C to +70°C (Multimode and Singlemode with ST or SC) / -20°C to +55°C (all others)
- EMC:
- EN61000-6-2/EN55022 Class B + A1 + A2
- Weight:
- 570 g
- Dimensions:
- 60 x 100 x 113 mm (60 x 120 x 113 mm incl. connector)
- Housing:
- Stainless steel, powder coated