RS232 serial port isolator, mini
The mini serial port isolators provides galvanic isolation between two serial devices connected to eachother to prevent a groundloop. A grounloop can cause serius damage to the serial port of the equipment. The K3 serie has a DB-9 connector on both sides or a DB-9 connector to one side and a terminal block to the other side. The K232-ISOL has a DB-25 connector on both sides.
Product variants
Article Number | Product Name | |
---|---|---|
1111-04-1103-00 + | K3-232 | + Request quote |
RS232<>RS232 port isolator, Rx/Tx/RTS/GND isolated coverter 9/9 pole sub-D | ||
1111-04-1103-01 + | K3-232-TB | + Request quote |
RS232<>RS232 port isolator, Rx/Tx/RTS/GND isolated coverter 9 pole sub-D/TB Connector | ||
1111-04-1103-02 + | K232-ISOL | + Request quote |
RS232<>RS232 port isolator, Rx/Tx/GND isolated coverter 25/25 pole sub-D |
Description
The K3-232 is an isolated RS232 to RS232 isolator. It is intended for full-duplex point to point communication.
- Isolation 100% tested at >1000V AC
- Very low cost
- No separate power supply required in most applications
- Baud rate independent 0-38400 baud
- Very low power CMOS
Do not confuse the K3-232 with imitations which claim to be self-powered but which in fact require power to be supplied to both sides of the converter, or which require about 40mA - far too much for any PC interface to supply. The K3-232 has a DB9 connector for both RS232 ports.
The K3-232-TB is an isolated RS232 to RS232 isolator. It is intended for full-duplex point to point communication.
- Isolation 100% tested at >1000V AC
- Very low cost
- No separate power supply required in most applications
- Baud rate independent 0-38400 baud
- Very low power CMOS
Do not confuse the K3-232 with imitations which claim to be self-powered but which in fact require power to be supplied to both sides of the converter, or which require about 40mA - far too much for any PC interface to supply. The K3-232-TB has a DB9 connector for the local RS232 port and a removable terminal block for the remote RS232 port.
The K232-ISOL is a RS232 isolator for 0-38400 baud.
- Isolation 100% tested at >1000V AC
- Plugs directly into IBM PC DB25 serial port
- Very low cost
- No separate power supply required in most applications
- Baud rate independent 0-38 kbaud
- MIL-STD conformally coated circuitry
- Thousands sold since 1993
Do not confuse these isolated models with imitations which claim to be self-powered but which in fact require power to be supplied to both sides of the converter, or which require about 40mA - far too much for any PC interface to supply.